Brake System Control Module Replacement
Single Use Fasteners and Components

Electronic Brake Control Module Bolt[6x]

Warning: The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.

Warning: Brake Fluid Irritant Warning

Caution: Brake Fluid Effects on Paint and Electrical Components Caution

Removal Procedure

  1. Prepare the brake system control module for removal. Control Module References

    2. Warning: Always ensure the Battery Maintenance Mode is inactive before disconnecting the low voltage 12 volt battery (or batteries). This mode can be active with the ignition off, regardless of whether the vehicle charging cord is plugged in or not. When this mode is active, the on-board high voltage battery charger(s) will energize the 12 volt battery cables and charge the 12 volt battery (or batteries). Disconnecting any battery cables while this mode is active may result in an electrical shock or a burn from hot battery cable leads.

  2. Check the 12 volt battery voltage with a digital multimeter before disconnecting any battery cables leads. If the voltage is 13.5 volts or above, the Battery Maintenance Mode is active. The technician must wait for the T18 battery charger to deactivate before disconnecting the battery negative cable. Charging System Description and Operation
  3. Disconnect the battery negative cable.Battery Negative Cable Disconnection and Connection

    4. Object ID: 5840625
  4. With the aid of an assistant, remove the fascia.(1)Front Bumper Fascia Removal and Installation

    5. Object ID: 5837776
  5. Body Side Upper Rear Applique Bolt(2)»Remove
  6. Front Fender Upper Rear Molding(1)»Remove

    7. Object ID: 5875924
  7. Headlamp Bolt(1)»Remove[5x]

    8. Object ID: 5875983
  8. Disconnect the electrical connector.
  9. Front Headlamp(1)»Remove

    10. Object ID: 5918463
  10. Electrical Connector@Brake System Control Module»Disconnect
  11. Electronic Brake Control Module Bolt(2)»Remove and DISCARD[6x]
  12. Brake System Control Module(1)»Remove

Installation Procedure


    Object ID: 5918463
  1. Brake System Control Module(1)»Install

    2. Caution: Refer to Fastener Caution.

  2. Electronic Brake Control Module Bolt(2)»Install NEW and tighten in sequence[6x]—Fastener Specifications
  3. Electrical Connector@Brake System Control Module»Connect

    4. Object ID: 5875983
  4. Front Headlamp(1)»Install
  5. Connect the electrical connector.

    6. Object ID: 5875924
  6. Headlamp Bolt(1)»Install and tighten[5x]—Fastener Specifications

    7. Object ID: 5837776
  7. Front Fender Upper Rear Molding(1)»Install
  8. Body Side Upper Rear Applique Bolt(2)»Install and tighten—Fastener Specifications

    9. Object ID: 5840625
  9. With the aid of an assistant, install the fascia.(1)Front Bumper Fascia Removal and Installation
  10. Connect the battery negative cable.Battery Negative Cable Disconnection and Connection
  11. Reprogram the brake system control module. Control Module References