Nitrogen Oxides Sensor Replacement - Position 2

Warning: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.

Warning: Avoid contact with HOT components. Wear safety glasses and protective gloves to avoid personal injury.

Removal Procedure
  1. Raise and support the vehicle.Lifting and Jacking the Vehicle

    2. Object ID: 5612577
  2. Disengage the nitrogen oxides sensor wiring harness clips (1).
  3. Nitrogen Oxides Sensor Nut(2)»Remove[2x]
  4. Disconnect the electrical connector (3).

    5. Object ID: 5612590
  5. Nitrogen Oxides Sensor(1)»Remove
Installation Procedure

    Object ID: 5612590

    Caution: Refer to Component Fastener Tightening Caution.

  1. Nitrogen Oxides Sensor(1)»Install and tighten—Fastener Specifications

    2. Object ID: 5612577
  2. Connect the electrical connector (3).

    3. Caution: Refer to Fastener Caution.

  3. Nitrogen Oxides Sensor Nut(2)»Install and tighten[2x]—Fastener Specifications
  4. Engage the nitrogen oxides sensor wiring harness clips (1).
  5. Remove the support and lower the vehicle.
  6. Perform the nitrogen oxides catalytic converter reductant loading reset. Nitrogen Oxides Catalytic Converter Reductant Loading Reset