Steering Gear Boot Replacement

Object ID: 4583599
Steering Gear Boot Replacement

Callout

Component Name

Preliminary Procedure

Steering Linkage Outer Tie Rod Replacement

1

Steering Linkage Inner Tie Rod Nut

Procedure

Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.

2

Steering Gear Boot Outer Clamp

3

Steering Gear Boot Inner Clamp

    Procedure
  1. Cut the steering gear boot inner clamp.

    DISCARD the clamp.

  2. Use the CH-22610 pliers to install the NEW steering gear boot inner clamp.

Note: Position the NEW steering gear boot inner clamp on the steering gear boot before installing the boot on the steering gear.

Special Tools

CH-22610 Keystone Clamp Pliers

Equivalent regional tools:Special Tools

4

Steering Gear Boot

    Procedure
  1. After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination.If corrosion or contamination is evident, replace the steering gear.Electric Dual Pinion Rack and Pinion Steering Gear Replacement
  2. Install the steering gear boot and ensure the boot is seated in the assembly groove of the steering gear before installing the steering gear boot clamps.