Steering Linkage Outer Tie Rod Replacement

Object ID: 4582714
Steering Linkage Outer Tie Rod Replacement

Callout

Component Name

Preliminary Procedure

Remove the front tire and wheel assembly.Tire and Wheel Removal and Installation

1

Steering Linkage Inner Tie Rod Nut

Procedure

Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.

Note: Do NOT tighten the steering linkage inner tie rod nut during installation. Tighten the nut after adjusting the front toe.

2

Steering Linkage Outer Tie Rod Nut

Caution: Refer to Fastener Caution.

Tighten

First Pass: 35 N·m (26 lb ft)

Final Pass: (80–90 degrees)

3

Steering Linkage Outer Tie Rod

    Procedure
  1. Use the CH-24319–B puller to separate the steering linkage outer tie rod from the steering knuckle.
  2. Clean the tapered surface of the steering knuckle.
  3. Inspect the steering linkage inner tie rod for bent or damaged threads.If necessary, replace the steering linkage inner tie rod.Steering Linkage Inner Tie Rod Replacement
  4. Measure and adjust the front toe.Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Special Tools

CH-24319–B Universal Steering Linkage and Tie Rod Puller

Equivalent regional tools:Special Tools