Steering Linkage Outer Tie Rod Replacement

Object ID: 3986356
Steering Linkage Outer Tie Rod Replacement

Callout

Component Name

Preliminary Procedure

Remove the front tire and wheel assembly.Tire and Wheel Removal and Installation

1

Steering Linkage Inner Tie Rod Nut

Procedure

Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.

Note: Do NOT tighten the steering linkage inner tie rod nut during installation. Tighten the nut after adjusting the front toe.

2

Steering Linkage Outer Tie Rod Nut

Caution: Refer to Fastener Caution.

Procedure

Use the EN-45059 meter to tighten the steering linkage outer tie rod nut.

Tighten

First Pass: 35 N·m (26 lb ft)

Final Pass: (30–45 degrees)

Special Tools

EN-45059 Torque Angle Meter

Equivalent regional tools:Special Tools

3

Steering Linkage Outer Tie Rod

Caution: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.

    Procedure
  1. Use the CH-24319–B puller to separate the steering linkage outer tie rod from the steering knuckle.
  2. Clean the tapered surface of the steering knuckle.
  3. Inspect the steering linkage inner tie rod for bent or damaged threads.If necessary, replace the steering linkage inner tie rod.Steering Linkage Inner Tie Rod Replacement
  4. Measure and adjust the front toe.Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
  5. Calibrate the power steering control module.Power Steering Control Module Calibration
Special Tools

CH-24319–B Universal Steering Linkage and Tie Rod Puller

Equivalent regional tools:Special Tools