Steering Linkage Inner Tie Rod Replacement

Object ID: 3986644
Steering Linkage Inner Tie Rod Replacement

Callout

Component Name

Preliminary Procedure

Steering Gear Boot Replacement

1

Steering Linkage Inner Tie Rod

Caution: Refer to Component Fastener Tightening Caution.

Caution: Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.

    Procedure
  1. Place an appropriate size crow foot wrench or equivalent on the flats of the steering linkage inner tie rod housing.
  2. Rotate the inner tie rod housing counterclockwise to remove the inner tie rod and clockwise to install the inner tie rod.
  3. Measure and adjust the front toe.Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
  4. Calibrate the power steering control module.Power Steering Control Module Calibration
Tighten

85 N·m (63 lb ft)