| Last Modified: 12-11-2024 | 6.11:8.1.0 | Doc ID: RM100000002Q1CR |
| Model Year Start: 2025 | Model: GR Corolla | Prod Date Range: [09/2024 - ] |
| Title: MAINTENANCE: G16E-GTS DRIVE BELT: REMOVAL; 2025 MY GR Corolla [09/2024 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use a Toyota genuine belt or an equivalent high strength belt when replacing the belt. If a high strength belt is not used, the durability of the belt may be insufficient. A high strength belt is reinforced with an aramid core and is stronger than other belts with a PET (polyester) or PEN (polyethylene naphthalate) core.
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
![2025 MY GR Corolla [09/2024 - ]; G16E-GTS (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE REAR ENGINE UNDER COVER RH
Click here
3. REMOVE FAN AND GENERATOR V BELT
(a) Insert a hexagon wrench (4 mm width across flats) into the securing hole of the ribbed belt tensioner assembly.
HINT:
Make sure to fully insert the hexagon wrench (4 mm width across flats).
(b) Rotate the ribbed belt tensioner assembly counterclockwise to loosen the tension.
(c) Pull the hexagon wrench (4 mm width across flats) as shown in the illustration to secure.
(d) Remove the fan and generator V belt from the V-ribbed belt tensioner assembly.
|
|