Last Modified: 12-11-2024 |
6.11:8.1.0 |
Doc ID: RM100000002Q052 |
Model Year Start: 2025 |
Model: GR Corolla |
Prod Date Range: [09/2024 -
] |
Title: G16E-GTS (BATTERY / CHARGING): BATTERY CURRENT SENSOR: REMOVAL; 2025 MY GR Corolla [09/2024 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor assembly removal/installation are shown below.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Front Camera System
|
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.
|
|
Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
2. REMOVE DECK BOARD ASSEMBLY
Click here
3. REMOVE BATTERY STATE SENSOR ASSEMBLY
(a) Remove spare wheel cushion.
Click here
(b) Disconnect the battery state sensor assembly connector.
|
|
(c) Remove the nut and disconnect the earth wire from the battery state sensor assembly.
|
|
(d) Loosen the nut and remove the battery state sensor assembly from the battery.
|
|
|