Last Modified: 01-27-2025 6.11:8.1.0 Doc ID: RM100000002PACC
Model Year Start: 2025 Model: Corolla Hatchback Prod Date Range: [09/2024 -           ]
Title: REAR SUSPENSION: REAR STABILIZER BAR (for Hatchback except Gasoline Model AWD): REMOVAL; 2025 MY Corolla Corolla Hatchback Corolla HV [09/2024 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear stabilizer bar removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Tire

ECU Data Initialization (When performing tire replacement after RoB code X2104 is output)

Active Torque Split AWD System

2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 -        ]; GF1A (TRANSFER / 4WD / AWD): ACTIVE TORQUE SPLIT AWD SYSTEM: CALIBRATION

PROCEDURE

1. REMOVE REAR WHEEL

Click here 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL

2. REMOVE REAR FLOOR SIDE MEMBER COVER LH

(a) w/ Cover:

(1) Remove the 3 bolts and clip (A).

(2) Disengage the clip (B) to remove the rear floor side member cover LH.

3. REMOVE REAR FLOOR SIDE MEMBER COVER RH

(a) w/ Cover:

(1) Remove the 3 bolts.

(2) Disengage the clip to remove the rear floor side member cover RH.

4. REMOVE REAR STABILIZER LINK ASSEMBLY LH

(a) Remove the cap from the rear stabilizer link assembly LH.

(b) Loosen the nut (A) of the rear stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

(c) Loosen the nut (B) of the rear stabilizer link assembly LH.

(d) Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.

NOTICE:

  • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
  • Make sure to perform this operation with the vehicle kept as low as possible.

*a

Wooden Block

*b

Jack

(e) Remove the bolt, 2 nuts and rear stabilizer link assembly LH.

5. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.

6. REMOVE REAR STABILIZER BAR

(a) Remove the 4 bolts and rear stabilizer bar from the rear suspension member sub-assembly.