Last Modified: 12-11-2024 6.11:8.1.0 Doc ID: RM100000002P84J
Model Year Start: 2025 Model: GR Corolla Prod Date Range: [09/2024 -           ]
Title: EA67F / EA68F (MANUAL TRANSMISSION / TRANSAXLE): PATTERN SELECT SWITCH: INSPECTION; 2025 MY Corolla Corolla Hatchback GR Corolla [09/2024 -        ]

INSPECTION

PROCEDURE

1. INSPECT COMBINATION SWITCH ASSEMBLY

(a) "iMT" switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 (MSW1) - 5 (E)

Pressed

Below 50 Ω

Not pressed

10 kΩ or higher

If the result is not as specified, replace the combination switch assembly.

*a

Component without harness connected

(Combination Switch Assembly)

(b) "DRIVE MODE" switch:

(1) Measure the resistance according to the value(s) in the table below.

*a

Component without harness connected

(Combination Switch Assembly)

"DRIVE +" Side

"DRIVE -" Side

Standard Resistance:

Tester Connection

Condition

Specified Condition

7 (SEL) - 5 (E)

Pushed and held at "DRIVE +" side

Below 50 Ω

Released (neutral position)

10 kΩ or higher

6 (E) - 5 (E)

Pushed and held at "DRIVE -" side

Below 50 Ω

Released (neutral position)

10 kΩ or higher

If the result is not as specified, replace the combination switch assembly.

(c) Check that the illumination illuminates.

(1) Apply battery voltage between the terminals of the switch, and check the illumination condition of the intelligent manual transmission switch (pattern select switch assembly).

OK:

Measurement Condition

Specified Condition

Battery positive (+) → 4 (ILL+)

Battery negative (-) → 1 (ILL-)

Illuminates

If the result is not as specified, replace the combination switch assembly.

*a

Component without harness connected

(Combination Switch Assembly)