Last Modified: 08-23-2025 6.11:8.1.0 Doc ID: RM100000002OV0D
Model Year Start: 2025 Model: GR Corolla Prod Date Range: [09/2024 - 08/2025]
Title: UC80F (AUTOMATIC TRANSMISSION / TRANSAXLE): TRANSMISSION CONTROL CABLE: REMOVAL; 2025 MY Corolla Corolla Hatchback GR Corolla [09/2024 - 08/2025]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedure

Effect/Inoperative when not Performed

Link

Gas leaks from exhaust system is repaired

Inspection After Repair
  • Poor idle, etc.
  • Engine start function, etc.

2023 - 2026 MY GR Corolla [09/2022 -        ]; G16E-GTS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION

PROCEDURE

1. REMOVE RADIATOR SUPPORT OPENING COVER

Click here 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2024 - 08/2025]; EXTERIOR PANELS / TRIM: FRONT BUMPER (for Hatchback, GR): REMOVAL+

2. REMOVE INLET NO. 1 AIR CLEANER

Click here 2025 MY GR Corolla [09/2024 - 08/2025]; G16E-GTS (EMISSION CONTROL): MONOLITHIC CONVERTER: REMOVAL+

3. REMOVE AIR CLEANER WITH AIR CLEANER HOSE

Click here 2025 MY GR Corolla [09/2024 - 08/2025]; G16E-GTS (EMISSION CONTROL): MONOLITHIC CONVERTER: REMOVAL+

4. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Click here 2023 - 2026 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]; DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: REMOVAL

5. REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR SUB-ASSEMBLY

(a) Remove the 3 nuts.

(b) Disengage the clip to remove the No. 1 front floor heat insulator sub-assembly.

6. REMOVE CONSOLE BOX ASSEMBLY

Click here 2025 - 2026 MY GR Corolla [09/2024 -        ]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (for G16E-GTS): REMOVAL

7. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Move the shift lever to N.

(b) Disconnect the transmission control cable assembly from the transmission floor shift assembly.

(c) Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.

NOTICE:

Do not forcibly pull the transmission control cable assembly into the cabin.

*a

Lock Nut

*b

Counterclockwise

(d) While disengaging the clip (A) as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip (A).

*a

Clip (A)

*b

45° to 60°

*c

Clip (B)

(e) Remove the clip (B) and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

(f) Remove the nut and disconnect the transmission control cable assembly from the vehicle body.

(g) Remove the 2 nuts and transmission control cable assembly from the vehicle body.