Last Modified: 12-11-2024 |
6.11:8.1.0 |
Doc ID: RM100000002OUWB |
Model Year Start: 2025 |
Model: GR Corolla |
Prod Date Range: [09/2024 -
] |
Title: METER / GAUGE / DISPLAY: HEADUP DISPLAY: REMOVAL; 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2024 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headup display (meter mirror sub-assembly) removal/installation are shown below.
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here
NOTICE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Front Camera System
|
-
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.*1
-
Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more.*2
|
|
Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
|
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
2. REMOVE METER MIRROR SUB-ASSEMBLY
(a) Disconnect the 2 connectors.
|
|
(c) Disengage the guide to remove the meter mirror sub-assembly.
3. REMOVE HEADUP DISPLAY WIRE
HINT:
Perform this procedure only when replacement of the headup display wire is necessary.
(a) Disengage the clamp to remove the headup display wire.
|
|
|