| Last Modified: 12-11-2024 | 6.11:8.1.0 | Doc ID: RM100000002OTZX |
| Model Year Start: 2025 | Model: GR Corolla | Prod Date Range: [09/2024 - ] |
| Title: EXTERIOR PANELS / TRIM: FRONT BUMPER (for Hatchback, GR): INSTALLATION; 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2024 - ] | ||
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
-
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
-
for Target Adjustment (Triangle Target):
Click here
![2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [11/2022 - ]; ADVANCED DRIVER ASSISTANCE SYSTEM: MILLIMETER WAVE RADAR SENSOR: TARGET ADJUSTMENT(TRIANGLE TARGET)](/t3Portal/stylegraphics/info.gif)
-
for Target Adjustment (Flat Surface Target):
Click here
-
for Driving Adjustment:
Click here
-
for Target Adjustment (Triangle Target):
-
w/ Parking Support Brake System:
-
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
Click here
-
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
PROCEDURE
1. INSTALL FRONT BUMPER ASSEMBLY
(a) Move the front bumper assembly into position and engage the 5 claws as shown in the illustration.
|
Install in this Direction |
(b) Install the 2 screws and bolt.
(c) Install the clip.
(d) Connect each connector.
(e) Engage the 4 claws in the order shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
|
|
Install in this Direction |
(f) Install the 10 screws.
(g) Engage the claw as shown in the illustration.
|
|
Install in this Direction |
HINT:
Use the same procedure for the RH side and LH side.
(h) Install the front bumper assembly with the 4 clips.
2. INSTALL RADIATOR SUPPORT OPENING COVER
(a) Install the radiator support opening cover with the 7 clips.
|
|