|
Last Modified: 01-27-2025 |
6.11:8.1.0 |
Doc ID: RM100000002OQOF |
|
Model Year Start: 2025 |
Model: GR Corolla |
Prod Date Range: [09/2024 -
] |
|
Title: G16E-GTS (ENGINE CONTROL): AIR FUEL RATIO SENSOR (for Sensor 1): REMOVAL; 2025 MY GR Corolla [09/2024 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
-
Replacement of air fuel ratio sensor (sensor 1)
-
Gas leak from exhaust system is repaired
|
Inspection after repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
PROCEDURE
1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Click here
2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL
Click here
3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
4. REMOVE RADIATOR SUPPORT OPENING COVER
Click here
5. REMOVE INLET NO. 1 AIR CLEANER
Click here
6. REMOVE AIR CLEANER WITH AIR CLEANER HOSE
Click here
7. REMOVE INTAKE AIR RESONATOR
Click here
8. REMOVE AIR FUEL RATIO SENSOR
|
(a) Disconnect the air fuel ratio sensor connector.
|
|
|
*A
|
for Manual Transaxle
|
|
*B
|
for Automatic Transaxle
|
|
|
(b) Disengage the 2 clamps.
|
(c) Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.
SST: 09224-00012
NOTICE:
If the air fuel ratio sensor has been struck or dropped, replace it.
|
|
|