| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000002D8B0 |
| Model Year Start: 2024 | Model: GR Corolla | Prod Date Range: [08/2023 - ] |
| Title: PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Front Side): REMOVAL; 2024 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [08/2023 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
Ultrasonic sensor |
Initialization of ultrasonic sensors |
Intuitive Parking Assist System |
|
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here
![2024 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [08/2023 - ]; EXTERIOR PANELS / TRIM: FRONT BUMPER (for Hatchback, GR): REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE NO. 3 RADIATOR TO SUPPORT SEAL
Click here
3. REMOVE NO. 2 RADIATOR TO SUPPORT SEAL
HINT:
Use the same procedure as for the No. 3 radiator to support seal.
4. REMOVE FRONT CENTER ULTRASONIC SENSOR
HINT:
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
|
(a) Disconnect the connector. |
|
(b) Disengage the 2 claws and remove the front center ultrasonic sensor as shown in the illustration.
|
Remove in this Direction |
5. REMOVE FRONT CORNER ULTRASONIC SENSOR
HINT:
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
|
(a) Disconnect the connector. |
|
(b) Disengage the 2 claws and remove the front corner ultrasonic sensor as shown in the illustration.
|
|
Remove in this Direction |
6. REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER
HINT:
- Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary.
- When removing the front corner ultrasonic sensor retainer, heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.
- The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
(a) Heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
Heating Temperature:
|
Item |
Temperature |
|---|---|
|
Front Bumper Assembly |
40 to 60°C (104 to 140°F) |
|
Front Corner Ultrasonic Sensor Retainer |
CAUTION:
- Do not touch the heat light and heated parts.
- Touching the heat light may result in burns.
- Touching heated parts for a long time may result in burns.
|
*a |
Heated Part |
|
*b |
Heat Light |
|
(b) Remove the front corner ultrasonic sensor retainer. |
|
7. REMOVE ULTRASONIC SENSOR CUSHION SET
HINT:
Only perform this procedure when removing and installing the ultrasonic sensor cushion set.
(a) Remove the ultrasonic sensor cushion set as shown in the illustration.
|
|
Remove in this Direction |
- |
- |
|
|