Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000002D0EV |
Model Year Start: 2024 |
Model: GR Corolla |
Prod Date Range: [08/2023 -
] |
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model with Electric Parking Brake System): C059704; Brake System Control Module "A" System Internal Failure; 2024 - 2025 MY Corolla Corolla Hatchback GR Corolla [08/2023 - ] |
DTC
|
C059704
|
Brake System Control Module "A" System Internal Failure
|
DESCRIPTION
The skid control ECU (brake actuator assembly) stores this DTC if malfunctions are found in a circuit inside the ECU by self diagnosis.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
MIL
|
Note
|
C059704
|
Brake System Control Module "A" System Internal Failure
|
Internal failure of the skid control ECU (brake actuator assembly).
|
Skid control ECU (brake actuator assembly)
|
Comes on
|
SAE Code: C0597
|
MONITOR DESCRIPTION
The skid control ECU (brake actuator assembly) has a self-diagnosis function. When the self-diagnosis function detects an internal malfunction in the skid control ECU, the skid control ECU (brake actuator assembly) illuminates the MIL and stores this DTC.
MONITOR STRATEGY
Related DTCs
|
C0597 (Case 1 to 4): ECU internal monitoring (VSC)
|
Required Sensors/Components(Main)
|
Skid control ECU (brake actuator assembly)
|
Required Sensors/Components(Related)
|
Skid control ECU (brake actuator assembly)
|
Frequency of Operation
|
Continuous
|
Duration
|
-: C0597 (Case 1-3, 1-4, 2, 3 and 4)
Immediately up to 0.84 seconds: C0597 (Case 1-1)
Immediately up to 1 second: C0597 (Case 1-2)
|
MIL Operation
|
Immediately
|
Sequence of Operation
|
None
|
TYPICAL ENABLING CONDITIONS
Monitor runs whenever the following DTCs are not stored
|
TMC's intellectual property
|
Other conditions belong to TMC's intellectual property
|
-
|
TYPICAL MALFUNCTION THRESHOLDS
TMC's intellectual property
|
-
|
COMPONENT OPERATING RANGE
TMC's intellectual property
|
-
|
CONFIRMATION DRIVING PATTERN
NOTICE:
When performing the normal judgment procedure, make sure that the driver door is closed and is not opened at any time during the procedure.
HINT:
-
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
-
When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
-
Connect the GTS to the DLC3.
-
Turn the ignition switch to ON and turn the GTS on.
-
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
-
Turn the ignition switch off.
-
Turn the ignition switch to ON and turn the GTS on.
-
Wait for 1 second or more. [*]
HINT:
[*]: Normal judgment procedure.
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
-
Enter the following menus: Chassis / Brake/EPB* / Utility / All Readiness.
*: Electric Parking Brake System
-
Check the DTC judgment result.
HINT:
-
If the judgment result shows NORMAL, the system is normal.
-
If the judgment result shows ABNORMAL, the system has a malfunction.
-
If the judgment result shows INCOMPLETE, perform driving pattern again.
PROCEDURE
1.
|
REPLACE BRAKE ACTUATOR ASSEMBLY
|
(a) Replace the skid control ECU (brake actuator assembly).
Click here
NEXT |
|
END
|
|