Last Modified: 05-13-2024 6.11:8.1.0 Doc ID: RM100000002BA4H
Model Year Start: 2023 Model: Corolla Hatchback Prod Date Range: [03/2023 -           ]
Title: K120 / K121 (CVT): OIL PRESSURE SENSOR: REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback [03/2023 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during oil pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedure

Effect/Inoperative when not Performed

Link

Replacement of oil pressure sensor

for K120

  • Perform reset memory
  • CVT oil pressure calibration
  • Perform road test to allow TCM to learn
  • Large shift shock
  • Deterioration of fuel efficiency

Initialization: 2023 - 2025 MY Corolla Corolla Hatchback [11/2022 -        ]; K120 / K121 (CVT): K120 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM: INITIALIZATION

Registration: 2019 - 2025 MY Corolla Corolla Hatchback [06/2018 -        ]; K120 / K121 (CVT): K120 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM: REGISTRATION

for K121

  • Perform reset memory
  • CVT oil pressure calibration
  • Perform road test to allow ECM to learn
  • Large shift shock
  • Deterioration of fuel efficiency

Initialization: 2023 - 2025 MY Corolla Corolla Hatchback [03/2023 -        ]; K120 / K121 (CVT): K121 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM: INITIALIZATION

Registration: 2023 - 2025 MY Corolla Corolla Hatchback [03/2023 -        ]; K120 / K121 (CVT): K121 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM: REGISTRATION

PROCEDURE

1. REMOVE OIL PRESSURE SENSOR

(a) Disconnect the oil pressure sensor connector.

(b) Using a 27 mm deep socket wrench, remove the oil pressure sensor from the rear transaxle case sub-assembly.