Last Modified: 07-31-2024 6.11:8.1.0 Doc ID: RM1000000029C3T
Model Year Start: 2023 Model: GR Corolla Prod Date Range: [11/2022 -           ]
Title: FRONT SUSPENSION: FRONT LOWER SUSPENSION ARM (for G16E-GTS RH Side): REMOVAL; 2023 - 2025 MY GR Corolla [11/2022 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly RH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Front wheel alignment adjustment
  1. Perform "Reset Memory"
  2. Perform "Calibration"
  • VSC is disabled or malfunctions
  • DTCs are output
  • Slip indicator light illuminates
  • ABS warning light illuminates

2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 -        ]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model without Electric Parking Brake System TMC Made): UTILITY

Tire

ECU Data Initialization (When performing tire replacement after RoB code X2104 is output)

Active Torque Split AWD System

2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 -        ]; GF1A (TRANSFER / 4WD / AWD): ACTIVE TORQUE SPLIT AWD SYSTEM: CALIBRATION

PROCEDURE

1. REMOVE FRONT WHEEL

Click here 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL

2. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here 2023 - 2025 MY GR Corolla [11/2022 -        ]; G16E-GTS (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL+

3. REMOVE REAR ENGINE UNDER COVER RH

(a) w/o Engine Under Cover Air Guide:

(1) Remove the 3 clips.

(b) w/ Engine Under Cover Air Guide:

(1) Remove the 3 clips.

(2) Remove the 2 screw.

(c) Remove the screw.

(d) Remove the clip and rear engine under cover RH from the vehicle.

4. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

(a) Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly RH from the front lower ball joint assembly RH.

(b) Remove the 2 bolts, nut and front lower No. 1 suspension arm sub-assembly RH from the front suspension crossmember sub-assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.