Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM10000000297AM |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [11/2022 -
] |
Title: WIPER / WASHER: WIPER AND WASHER SYSTEM (for Gasoline Model): Washer Fluid Level Warning Switch Circuit; 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [11/2022 - ] |
Washer Fluid Level Warning Switch Circuit
|
DESCRIPTION
When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly.
WIRING DIAGRAM
PROCEDURE
1.
|
READ VALUE USING TECHSTREAM
|
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Combination Meter > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
Washer Level Warning Switch
|
Washer fluid level warning switch
|
OFF or ON
|
OFF: Washer fluid level not low
ON: Washer fluid level low
|
-
|
Body Electrical > Combination Meter > Data List
Tester Display
|
Washer Level Warning Switch
|
OK:
The Techstream display changes correctly in response to the washer fluid level.
NG
|
|
|
2.
|
INSPECT LEVEL WARNING SWITCH ASSEMBLY
|
(a) Remove the level warning switch assembly.
Click here
(b) Inspect the level warning switch assembly.
Click here
OK
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (LEVEL WARNING SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
|
(a) Disconnect the I4 combination meter assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A138-1 (S) - I4-13 (WLVL)
|
Always
|
Below 1 Ω
|
A138-1 (S) or I4-13 (WLVL) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
4.
|
CHECK HARNESS AND CONNECTOR (LEVEL WARNING SWITCH ASSEMBLY - BODY GROUND)
|
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A138-2 (E) - Body ground
|
Always
|
Below 1 Ω
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|