| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM1000000028TG6 |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [11/2022 - ] |
| Title: G16E-GTS (LUBRICATION): OIL PUMP: REMOVAL; 2023 - 2025 MY GR Corolla [11/2022 - ] | ||
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEELS
Click here
![2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE REAR ENGINE UNDER COVER RH
Click here
3. REMOVE FRONT BUMPER ASSEMBLY (w/ Engine Under Cover Air Guide)
Click here
4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Engine Under Cover Air Guide)
Click here
5. DRAIN WASHER FLUID (w/ Engine Under Cover Air Guide)
Click here
6. REMOVE INLET HOSE (w/ Engine Under Cover Air Guide)
Click here
7. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (w/ Engine Under Cover Air Guide)
Click here
8. REMOVE NO. 2 ENGINE UNDER COVER AIR GUIDE (w/ Engine Under Cover Air Guide)
Click here
9. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
10. REMOVE FAN AND GENERATOR V BELT
Click here
11. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY
Click here
12. REMOVE NO. 1 AIR TUBE
|
(a) Remove the 2 bolts. |
|
(b) Loosen the 2 hose clamps to remove the No. 1 air tube from the No. 2 air hose and No. 3 air hose.
13. REMOVE NO. 2 AIR HOSE
|
(a) Loosen the hose clamp to remove the No. 2 air hose from the turbocharger sub-assembly. |
|
14. DISCONNECT ENGINE WIRE
|
(a) Remove the bolt and disconnect the engine wire from the timing chain cover assembly. |
|
15. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Click here
16. REMOVE TIMING GEAR COVER INSULATOR
|
(a) Remove the timing gear cover insulator from the timing chain cover assembly. |
|
17. REMOVE CRANKSHAFT PULLEY ASSEMBLY
Click here
18. REMOVE TIMING CHAIN COVER ASSEMBLY
|
(a) Remove the 12 bolts and seal washer. |
|
(b) Remove the timing chain cover assembly by prying between the timing chain cover assembly and oil pan sub-assembly, cylinder block sub-assembly with a screwdriver with its tip wrapped with protective tape.
|
(c) Remove the 2 oil pump gaskets from the cylinder block sub-assembly. NOTICE: Be careful not to damage the contact surfaces of the oil pan sub-assembly. |
|
19. REMOVE TIMING CHAIN COVER OIL SEAL
Click here
|
|