Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000028TFB |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [11/2022 -
] |
Title: MAINTENANCE: G16E-GTS DRIVE BELT: INSTALLATION; 2023 - 2025 MY GR Corolla [11/2022 - ] |
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use a Toyota genuine belt or an equivalent high strength belt when replacing the belt. If a high strength belt is not used, the durability of the belt may be insufficient. A high strength belt is reinforced with an aramid core and is stronger than other belts with a PET (polyester) or PEN (polyethylene naphthalate) core.
PROCEDURE
1. INSTALL FAN AND GENERATOR V BELT
HINT:
When reusing the fan and generator V belt, check the ribs and back of the fan and generator V belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the fan and generator V belt.
(a) Set the fan and generator V belt onto each pulley as shown in the illustration.
|
|
*1
|
Crankshaft Pulley Assembly
|
*2
|
Generator Assembly
|
*3
|
Compressor with Pulley Assembly
|
*4
|
Water Pump Assembly
|
|
|
(b) Turn the V-ribbed belt tensioner assembly clockwise and remove the hexagon wrench (4 mm width across flats).
(c) After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley by hand.
|
|
2. INSTALL NO. 2 ENGINE UNDER COVER AIR GUIDE (w/ Engine Under Cover Air Guide)
Click here
3. INSTALL WINDSHIELD WASHER JAR ASSEMBLY (w/ Engine Under Cover Air Guide)
Click here
4. INSTALL INLET HOSE (w/ Engine Under Cover Air Guide)
Click here
5. ADD WASHER FLUID (w/ Engine Under Cover Air Guide)
Click here
6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Engine Under Cover Air Guide)
Click here
7. INSTALL REAR ENGINE UNDER COVER RH
Click here
8. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
|