Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000028TAK |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [11/2022 -
] |
Title: EXTERIOR PANELS / TRIM: BLACK OUT TAPE (for Rear Door): INSTALLATION; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [11/2022 - ] |
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
2. REPAIR INSTRUCTION
Click here
3. INSTALL REAR DOOR OUTSIDE STRIPE
(a) Refer to the illustration to position a new rear door outside stripe.
*A
|
LH Side
|
*B
|
RH Side
|
*a
|
Point A
|
*b
|
Point B
|
*c
|
Edge of Curved Surface
|
*d
|
Straight
|
*e
|
Triangle
|
-
|
-
|
Standard Measurement:
Area
|
Measurement
|
Area
|
Measurement
|
A
|
5.0 mm (0.197 in.)
|
B
|
5.0 mm (0.197 in.)
|
C
|
19.0 mm (0.748 in.)
|
D
|
2.6 mm (0.102 in.)
|
E
|
1.0 mm (0.0394 in.)
|
F
|
2.6 mm (0.102 in.)
|
G
|
1.0 mm (0.0394 in.)
|
-
|
-
|
(b) Remove the release paper and install the rear door outside stripe.
4. INSTALL REAR DOOR QUARTER WINDOW WEATHERSTRIP WITH REAR DOOR QUARTER WINDOW GLASS
Click here
5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY
Click here
6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Click here
7. CONNECT REAR DOOR WEATHERSTRIP
Click here
8. INSTALL REAR DOOR GLASS RUN
Click here
9. INSTALL REAR DOOR WINDOW REGULATOR LIFT ARM BRACKET (w/o Rear Seat Assembly)
Click here
10. INSTALL REAR DOOR SERVICE HOLE COVER
Click here
11. INSTALL REAR DOOR PANEL PROTECTOR
Click here
12. INSTALL REAR DOOR NO. 1 VENT SEAL
Click here
13. INSTALL REAR DOOR FRAME GARNISH
Click here
14. INSTALL REAR SPEAKER ASSEMBLY (w/ SPEAKER)
Click here
15. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here
16. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Click here
17. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
Click here
18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click here
19. INSTALL SPARE WHEEL CUSHION
Click here
20. INSTALL DECK BOARD ASSEMBLY
Click here
21. INITIALIZE POWER WINDOW CONTROL SYSTEM
Click here
22. INSPECT POWER WINDOW OPERATION
Click here
|