Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000028ILE |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [11/2022 -
] |
Title: HEATING / AIR CONDITIONING: COMPRESSOR (for G16E-GTS): REMOVAL; 2023 - 2025 MY GR Corolla [11/2022 - ] |
REMOVAL
PROCEDURE
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Click here
2. REMOVE FRONT BUMPER ASSEMBLY (w/o Rear Seat Assembly)
Click here
3. REMOVE FRONT WHEEL RH (w/o Rear Seat Assembly)
Click here
4. REMOVE FRONT FENDER LINER RH (w/o Rear Seat Assembly)
Click here
5. DRAIN WASHER FLUID (w/o Rear Seat Assembly)
Click here
6. REMOVE INLET HOSE (w/o Rear Seat Assembly)
Click here
7. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (w/o Rear Seat Assembly)
Click here
8. REMOVE NO. 2 ENGINE UNDER COVER AIR GUIDE (w/o Rear Seat Assembly)
Click here
9. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
10. REMOVE REAR ENGINE UNDER COVER RH
Click here
11. REMOVE FAN AND GENERATOR V BELT
Click here
12. DISCONNECT NO. 2 AIR HOSE
(a) Loosen the hose clamp and disconnect the No. 2 air hose.
|
|
13. DISCONNECT NO. 3 AIR HOSE
(a) Loosen the hose clamp and disconnect the No. 3 air hose.
|
|
14. REMOVE NO. 1 AIR TUBE
(a) Remove the 2 bolts and No. 1 air tube.
|
|
15. DISCONNECT SUCTION HOSE SUB-ASSEMBLY
(a) Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.
|
|
(b) Remove the O-ring from the suction hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
16. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
(a) Remove the bolt and disconnect the discharge hose sub-assembly from the compressor assembly with pulley.
|
|
(b) Remove the O-ring from the discharge hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
17. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY
(a) Disconnect the connector.
|
|
(b) Remove the 2 bolts and 2 nuts.
|
Bolt
|
|
Nut
|
(c) Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with pulley.
|
|
|