Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000028H9M |
Model Year Start: 2023 |
Model: Corolla Hatchback |
Prod Date Range: [11/2022 -
] |
Title: K120 / K121 (CVT): K120 REVOLUTION SENSOR (NOUT SENSOR): REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback [11/2022 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during transmission revolution sensor (NOUT) removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure
|
Necessary Procedure
|
Effect/Inoperative when not Performed
|
Link
|
Replacement of ECM
|
Vehicle Identification Number (VIN) registration
|
MIL comes on
|
|
Update ECU security key
|
Vehicle Control History (RoB) are stored
|
|
ECU communication ID registration (Immobiliser system)
|
Engine start function
|
|
-
Perform reset memory
-
CVT oil pressure calibration
-
Perform road test to allow TCM to learn
|
-
Large shift shock
-
Deterioration of fuel efficiency
|
for Initialization
for Registration
|
Replacement of ECM*2
|
Code registration (Smart Key System (for Gasoline Model, Start Function))
|
-
Wireless Door Lock Control System (for Gasoline Model with Smart Key System)
-
Smart Key System (for Gasoline Model, Entry Function)
-
Smart Key System (for Gasoline Model, Start Function)
-
Steering lock function*3
|
|
Replacement of ECM*1
|
Code registration (Immobiliser system)
|
-
Engine start
-
Telematics System
|
|
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Front Camera System
|
Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more.
|
|
Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
|
PROCEDURE
1. REMOVE BATTERY
Click here
2. REMOVE ECM
Click here
3. REMOVE BATTERY CLAMP SUB-ASSEMBLY
Click here
4. REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)
(a) Disconnect the transmission revolution sensor (NOUT) connector.
|
|
(b) Remove the bolt and transmission revolution sensor (NOUT) from the transaxle case sub-assembly.
|
|
(c) Remove the O-ring from the transmission revolution sensor (NOUT).
|
|
|