G16E-GTS (ENGINE CONTROL): CRANKSHAFT POSITION SENSOR: REMOVAL; 2023 - 2025 MY GR Corolla [11/2022

Last Modified: 05-13-2024	6.11:8.1.0	Doc ID: RM1000000028GZ0
Model Year Start: 2023	Model: GR Corolla	Prod Date Range: [11/2022 - ]
Title: G16E-GTS (ENGINE CONTROL): CRANKSHAFT POSITION SENSOR: REMOVAL; 2023 - 2025 MY GR Corolla [11/2022 - ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function when Necessary Procedure not Performed	Necessary Procedure	Link
Front Camera System	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.

Learning completes when vehicle is operated normally

Effect/Inoperative Function when Necessary Procedure not Performed	Necessary Procedure	Link
Power Door Lock Control System Back door opener	Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.

PROCEDURE

1. REMOVE STARTER ASSEMBLY

Click here

2. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector.

(b) Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.

(1) Remove the O-ring from the crankshaft position sensor.

NOTICE:

Make sure to only remove the O-ring with bare hands.
When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.