- Back door opener*1
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000028GRP |
| Model Year Start: 2023 | Model: Corolla Hatchback | Prod Date Range: [11/2022 - 03/2023] |
| Title: M20A-FKS (BATTERY / CHARGING): GENERATOR (for Transaxle CVT with Denso Made Generator): REMOVAL; 2023 MY Corolla Corolla Hatchback [11/2022 - 03/2023] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during generator assembly removal/installation are shown below.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Front Camera System |
Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more. |
|
Learning completes when vehicle is operated normally
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
| *1: for Hatchback | ||
|
Power Door Lock Control System |
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
![2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ]; SETUP: WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL: BEFORE DISCONNECTING BATTERY](/t3Portal/stylegraphics/info.gif)
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
3. REMOVE RADIATOR SUPPORT OPENING COVER
-
for Hatchback
Click here
-
for Sedan with Illumination
Click here
-
for Sedan without Illumination
Click here
4. REMOVE INLET NO. 1 AIR CLEANER
Click here
5. REMOVE V-RIBBED BELT
Click here
6. REMOVE GENERATOR ASSEMBLY
|
(a) Disconnect the generator assembly connector. |
|
(b) Open the terminal cap.
(c) Remove the nut and disconnect the wire harness from terminal B.
(d) Remove the bolt and separate the wire harness clamp bracket from the generator assembly.
|
(e) Remove the 2 nuts bolt and generator assembly. |
|
|
|