- Replacement of throttle body with motor assembly
- Cleaning the deposits from the throttle body with motor assembly
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000028GQY |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [11/2022 - ] |
| Title: G16E-GTS (ENGINE CONTROL): THROTTLE BODY: REMOVAL; 2023 - 2025 MY GR Corolla [11/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Inspection after repair |
|
|
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Front Camera System |
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. |
|
Learning completes when vehicle is operated normally
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
PROCEDURE
1. REMOVE INTAKE MANIFOLD
Click here
![2023 - 2025 MY GR Corolla [11/2022 - ]; G16E-GTS (INTAKE / EXHAUST): INTAKE MANIFOLD: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE AIR TUBE ASSEMBLY
|
(a) Remove the 4 bolts and air tube assembly from the throttle body with motor assembly. NOTICE: If the throttle body with motor assembly has been struck or dropped, replace it. |
|
(b) Remove the No. 2 throttle body gasket from the air tube assembly.
3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
|
(a) Remove the throttle body with motor assembly from the intake manifold. NOTICE: If the throttle body with motor assembly has been struck or dropped, replace it. |
|
(b) Remove the throttle body gasket from the intake manifold.
|
|