- Back door opener
| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM1000000028GQ7 |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [11/2022 - ] |
| Title: G16E-GTS (BATTERY / CHARGING): GENERATOR: REMOVAL; 2023 - 2025 MY GR Corolla [11/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Front Camera System |
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. |
|
Learning completes when vehicle is operated normally
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Power Door Lock Control System |
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
![2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ]; SETUP: WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL: BEFORE DISCONNECTING BATTERY](/t3Portal/stylegraphics/info.gif)
2. REMOVE DECK BOARD ASSEMBLY
Click here
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(a) for Type A:
(1) Remove spare wheel cushion.
Click here
|
(b) Loosen the nut and disconnect the cable from the negative (-) battery terminal. |
|
4. REMOVE V-RIBBED BELT
Click here
5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Click here
6. REMOVE GENERATOR ASSEMBLY
|
(a) Disconnect the 3 connectors. |
|
(b) Remove the bolt and disconnect the wire harness clamp bracket.
(c) Open the terminal cap.
(d) Remove the nut and disconnect the engine wire from terminal B.
|
(e) Remove the bolt and 2 nuts. |
|
|
(f) Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator assembly. |
|
|
|