Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000028GQ6 |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [11/2022 -
] |
Title: G16E-GTS (STARTING): STARTER: REMOVAL; 2023 - 2025 MY GR Corolla [11/2022 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Front Camera System
|
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.
|
|
Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
2. REMOVE DECK BOARD ASSEMBLY
Click here
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
4. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
5. DRAIN ENGINE COOLANT
Click here
6. DRAIN ENGINE OIL
Click here
7. REMOVE OIL PRESSURE AND TEMPERATURE SENSOR
Click here
8. DISCONNECT NO. 6 WATER BY-PASS HOSE
Click here
9. DISCONNECT NO. 5 WATER BY-PASS HOSE
Click here
10. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY
Click here
11. REMOVE FLYWHEEL HOUSING SIDE COVER
(a) Disconnect the claw as shown in the illustration to remove the flywheel housing side cover.
|
|
12. REMOVE STARTER ASSEMBLY
(a) Disconnect the starter assembly connector.
|
|
(b) Open the terminal cap.
(c) Disengage the clamp to separate the engine wire.
|
|
(d) Remove the nut and disconnect the engine wire from terminal 30.
(e) Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.
NOTICE:
Make sure that the flywheel housing under cover is securely installed.
Click here
(f) Remove the bolt and wire harness clamp bracket from the starter assembly.
|
|
|