| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000028FZX |
| Model Year Start: 2023 | Model: Corolla Hatchback | Prod Date Range: [11/2022 - ] |
| Title: M20A-FKS (FUEL): FUEL MAIN VALVE (w/o Canister Pump Module (for Torsion Beam Type Suspension)): REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback [11/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel main valve assembly removal/installation are shown below.
CAUTION:
-
Never perform work on fuel system components near any possible ignition sources.
- Vaporized fuel could ignite, resulting in a serious accident.
-
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
- Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Front Camera System |
Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more. |
|
PROCEDURE
1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Click here
![2023 - 2025 MY Corolla Corolla Hatchback [11/2022 - ]; M20A-FKS (FUEL): FUEL PUMP (w/o Canister Pump Module (for Torsion Beam Type Suspension)): REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE FUEL PRESSURE REGULATOR HOLDER
|
(a) Disengage the 2 claws and remove the fuel pressure regulator holder from the fuel suction tube with pump and gauge assembly. |
|
3. REMOVE FUEL MAIN VALVE ASSEMBLY
|
(a) Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel suction tube with pump and gauge assembly. NOTICE: Pull out the fuel main valve assembly carefully because the O-ring is firmly installed between the fuel main valve assembly and the fuel suction tube with pump and gauge assembly. |
|
|
(b) Remove the O-ring from the fuel main valve assembly. NOTICE: Do not remove the mesh and mini-clip from the fuel main valve assembly. |
|
|
|