Actuation Area-linked*1
|
When a registered key is brought within any vehicle exterior detection area around the doors, the lights that operate turn on.
|
-
Map Light Assembly
-
No. 1 Room Light Assembly
|
Door Lock/Unlock-linked
(When entering the vehicle)
|
In the above situation, the lights listed to the right illuminate when any door is unlocked.
|
-
Map Light Assembly
-
No. 1 Room Light Assembly
|
Door Open/Close-linked
(When entering the vehicle)
|
In the above situation, the lights listed to the right illuminate when any door is opened.
|
-
Map Light Assembly
-
No. 1 Room Light Assembly
-
Push Start Switch Illumination*1
|
Brake-linked
|
In the above situation, the lights listed to the right illuminate when the brake pedal is depressed.
|
-
Full illumination
-
Map Light Assembly
-
No. 1 Room Light Assembly
-
Blinking
-
Push Start Switch Illumination*1
|
Push Start Switch-linked*1
|
In the above situation, the lights listed to the right illuminate when the ignition switch is turned from off or ACC to ON.
|
Push Start Switch Illumination*1
|
Shift Position-linked*2
|
In the above situation, the lights listed to the right illuminate when the shift state is changed to other than P.
|
Push Start Switch Illumination*1
|
IG ON → OFF
(When exiting the vehicle)
|
In the above situation, the lights listed to the right illuminate when the ignition switch is turned from ON to off or ACC.
|
-
Map Light Assembly
-
No. 1 Room Light Assembly
-
Push Start Switch Illumination*1
|
Door Lock/Unlock-linked
(When exiting the vehicle)
|
In the above situation, the lights listed to the right dimly illuminate when any door is locked for approximately 7.5 seconds, or until the electrical key transmitter is carried outside of the detection area, and then turn off.
|
-
Map Light Assembly
-
No. 1 Room Light Assembly
|
Delay
|
When approximately 15 seconds elapse after any of the following conditions is met, the lights that operate turn off:
-
An actuation area-linked function is used.*1
-
The door unlock-linked function is active.
-
Any door is opened and then all doors are closed when the ignition switch is off.
-
The ignition switch is turned from ACC or ON to off when all doors are closed.
|
-
Map Light Assembly
-
No. 1 Room Light Assembly
|
When approximately 40 seconds elapse after any of the following conditions is met, the lights that operate turn off:
-
Any front door is opened and then front doors are closed when the ignition switch is off.
-
The ignition switch is turned from on (ACC) or on (IG) to off when all doors are closed.
|
Push Start Switch Illumination*1
|