| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM10000000275IR |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: EXTERIOR PANELS / TRIM: REAR DOOR BELT MOULDING: INSTALLATION; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022] | ||
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
2. INSTALL REAR DOOR BELT MOULDING (for Hatchback)
(a) Engage the 7 claws as shown in the illustration to install a new rear door belt moulding.
|
Install in this Direction |
3. INSTALL REAR DOOR BELT MOULDING (for Sedan)
(a) Engage the 8 claws as shown in the illustration to install a new rear door belt moulding.
|
|
Install in this Direction |
4. INSTALL REAR DOOR QUARTER WINDOW WEATHERSTRIP WITH REAR DOOR QUARTER WINDOW GLASS
Click here
![2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; DOOR / HATCH: REAR DOOR: REASSEMBLY+](/t3Portal/stylegraphics/info.gif)
5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY
Click here
6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Click here
7. CONNECT REAR DOOR WEATHERSTRIP
Click here
8. INSTALL REAR DOOR GLASS RUN
Click here
9. INSTALL REAR DOOR SERVICE HOLE COVER
Click here
10. INSTALL REAR DOOR PANEL PROTECTOR
Click here
11. INSTALL REAR DOOR NO. 1 VENT SEAL
Click here
12. INSTALL REAR DOOR FRAME GARNISH
Click here
13. INSTALL REAR SPEAKER ASSEMBLY
Click here
14. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here
15. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Click here
16. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
Click here
17. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for G16E-GTS: Click here
for M20A-FKS: Click here
for 2ZR-FAE: Click here
for 2ZR-FXE: Click here
18. INSTALL SPARE WHEEL CUSHION (for G16E-GTS)
Click here
19. INSTALL DECK BOARD ASSEMBLY (for G16E-GTS)
Click here
20. INITIALIZE POWER WINDOW CONTROL SYSTEM
for TMC Made:
Click here
except TMC Made:
Click here
21. INSPECT POWER WINDOW OPERATION
for TMC Made:
Click here
except TMC Made:
Click here
|
|