Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM10000000275GG |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 -
] |
Title: TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER (for Hatchback): REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning ECU and receiver removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure
|
Necessary Procedures
|
Effects/Inoperative when not Performed
|
Link
|
Tire pressure warning ECU and receiver
|
-
ID Registration
-
Initialization
-
Tire Position Identification
|
Tire Pressure Warning System
|
|
NOTICE:
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
Click here
PROCEDURE
1. REMOVE ROOF SIDE INNER GARNISH LH
Click here
2. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
NOTICE:
-
Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
-
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
(b) Disengage the 2 guides.
(c) Disconnect the connector to remove the tire pressure warning ECU and receiver.
|