| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM10000000273V1 |
| Model Year Start: 2023 | Model: Corolla Hatchback | Prod Date Range: [09/2022 - 11/2022] |
| Title: FRONT SUSPENSION: FRONT LOWER SUSPENSION ARM (for M20A-FKS LH Side): INSTALLATION; 2023 MY Corolla Corolla Hatchback [09/2022 - 11/2022] | ||
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
For models with manual transaxle, the front lower No. 1 suspension arm sub-assembly LH can be installed without removing the front suspension crossmember sub-assembly.
PROCEDURE
1. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH (for CVT)
|
(a) Temporarily install the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the 2 bolts and nut. |
|
2. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY (for CVT)
Click here
![2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; FRONT SUSPENSION: FRONT SUSPENSION MEMBER: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
3. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH (for Manual Transaxle)
|
(a) Temporarily install the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the 2 bolts and nut. |
|
(b) Connect the front lower No. 1 suspension arm sub-assembly LH to the front lower ball joint assembly LH with the bolt and 2 nuts.
Torque:
89 N·m {908 kgf·cm, 66 ft·lbf}
4. INSTALL FRONT WHEEL (for Manual Transaxle)
Click here
5. STABILIZE SUSPENSION
Click here
6. FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
(a) Using SST, fully tighten the bolt (A).
SST: 09961-01270
|
*a |
Torque Wrench Fulcrum Length |
|
Turn |
Torque:
Specified tightening torque :
240 N·m {2447 kgf·cm, 177 ft·lbf}
HINT:
-
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click here
-
When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 600 mm (1.97 ft.)):
180 N*m (1835 kgf*cm, 133 ft.*lbf)
(b) Fully tighten the bolt (B).
Torque:
125 N·m {1275 kgf·cm, 92 ft·lbf}
NOTICE:
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
7. INSTALL REAR ENGINE UNDER COVER LH (for Manual Transaxle)
Click here
8. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for Manual Transaxle)
Click here
9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Click here
|
|