INSTALLATION

PROCEDURE

1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY

(a) Install the floor shift shift lever assembly to the vehicle body with the 4 bolts.

Torque:

12 N·m {122 kgf·cm, 9 ft·lbf}

2. CONNECT WIRE HARNESS

(a) Engage the 4 clamps to connect the wire harness to the floor shift shift lever assembly.

3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.

*a Nut *b Stopper *c Turn *d Push

(b) Install the transmission control cable assembly to the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and press in the stopper. NOTICE: Do not forcibly pull the transmission control cable assembly into the cabin. HINT: If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.

*1 Shift Lever Retainer (Floor Shift Lever Assembly) *a Nut *b Stopper *c Spring *d Push

(c) Connect the transmission control shift cable to the floor shift shift lever assembly.

(d) Connect the transmission control select cable to the floor shift shift lever assembly with the clip.

4. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY

Click here

5. INSTALL CONSOLE BOX ASSEMBLY

Click here