Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM10000000270PB |
Model Year Start: 2023 |
Model: Corolla |
Prod Date Range: [09/2022 - 11/2022] |
Title: 2ZR-FAE (ENGINE CONTROL): ENGINE COOLANT TEMPERATURE SENSOR: REMOVAL; 2023 MY Corolla [09/2022 - 11/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Replacement of engine coolant temperature sensor
|
Inspection after repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed
|
Necessary Procedure
|
Link
|
Pre-collision System (for TMMMS Made)
|
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.
|
|
Lane Tracing Assist System (for TMMMS Made)
|
Lane Departure Alert System (for TMMMS Made)
|
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here
2. REMOVE BATTERY
Click here
3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR
(a) Disconnect the engine coolant temperature sensor connector.
|
|
(b) Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.
SST: 09817-33191
NOTICE:
If the engine coolant temperature sensor has been struck or dropped, replace it.
|
|
(c) Remove the gasket from the engine coolant temperature sensor.
|