| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM10000000270LP |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: ADVANCED DRIVER ASSISTANCE SYSTEM: FRONT RADAR SENSOR SYSTEM (for TMC Made): C1A1100; Front Radar Sensor Optical Axis Misalignment Malfunction; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022] | ||
|
DTC |
C1A1100 |
Front Radar Sensor Optical Axis Misalignment Malfunction |
DESCRIPTION
The millimeter wave radar sensor assembly performs self-diagnosis to check for misalignment of its beam axis. If misalignment is detected, the millimeter wave radar sensor assembly stores DTC C1A1100.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
Priority |
|---|---|---|---|---|---|
|
C1A1100 |
Front Radar Sensor Optical Axis Misalignment Malfunction |
When the ignition switch is ON, the millimeter wave radar sensor assembly detects beam axis misalignment |
|
Front Radar Sensor |
A |
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle and a DTC may be stored.
-
When the millimeter wave radar sensor assembly has been replaced with a new one, it is necessary to perform millimeter wave radar sensor assembly beam axis alignment and to clear the vehicle control history. Before performing the Driving Adjustment, make sure to read Before Starting Driving Adjustment.
HINT:
Beam axis alignment of the millimeter wave radar sensor assembly can be performed using either Triangle Target, Flat Surface Target or Driving Adjustment.
Triangle Target: Click here
![2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; ADVANCED DRIVER ASSISTANCE SYSTEM: MILLIMETER WAVE RADAR SENSOR (for TMC Made): TARGET ADJUSTMENT(TRIANGLE TARGET)](/t3Portal/stylegraphics/info.gif)
Flat Surface Target: Click here
Driving Adjustment: Click here
PROCEDURE
|
1. |
ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
HINT:
Beam axis alignment of the millimeter wave radar sensor assembly can be performed using either Triangle Target, Flat Surface Target or Driving Adjustment.
Triangle Target: Click here
Flat Surface Target: Click here
Driving Adjustment: Click here
|
|
2. |
CLEAR DTC |
(a) Clear the DTCs.
Body Electrical > Front Radar Sensor > Clear DTCs
|
|
3. |
CHECK FOR DTCs |
Pre-procedure1
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ON.
(c) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
Procedure1
(d) Check for DTCs.
Body Electrical > Front Radar Sensor > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTC C1A1100 is not output |
A |
|
DTC C1A1100 is output |
B |
Post-procedure1
(e) None.
| A |
|
END |
| B |
|
|
|