for TMC Made
- Update ECU security key
| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM10000000270KC |
| Model Year Start: 2023 | Model: Corolla Hatchback | Prod Date Range: [09/2022 - 11/2022] |
| Title: K120 / K121 (CVT): K120 TCM: REMOVAL; 2023 MY Corolla Corolla Hatchback [09/2022 - 11/2022] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during TCM removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replacement Part or Procedure |
Necessary Procedure |
Effect/Inoperative when not Performed |
Link |
|---|---|---|---|
|
*1: Not necessary when TCM replaced with new one.
*2: It is only necessary TMMMS Made Models |
|||
|
Replacement of TCM (If transaxle compensation code read from TCM) |
|
Vehicle Control History (RoB) are stored |
|
|
|
|
|
|
Replacement of TCM (If transaxle compensation code not read from TCM) |
for TMC Made
|
Vehicle Control History (RoB) are stored |
|
|
|
|
|
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
|
Front Camera System (for TMC Made) |
Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more. |
|
|
Pre-collision System (for TMMMS Made) |
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. |
|
|
Lane Tracing Assist System (for TMMMS Made) |
||
|
Lane Departure Alert System (for TMMMS Made) |
Learning completes when vehicle is operated normally
|
Effect/Inoperative Function when Necessary Procedure not Performed |
Necessary Procedure |
Link |
|---|---|---|
| *1: for Hatchback | ||
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click here
![2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ]; SETUP: WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL: BEFORE DISCONNECTING BATTERY](/t3Portal/stylegraphics/info.gif)
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
4. REMOVE REAR ENGINE UNDER COVER LH
Click here
5. REMOVE TCM
|
(a) Remove the bolt to disconnect the engine wire from the No. 2 transmission control ECU bracket. |
|
(b) Disengage the claw, rotate the lever and disconnect the TCM connector.
|
Remove in this Direction |
|
(c) Remove the 2 bolts and TCM from the continuously variable transaxle assembly. |
|
6. REMOVE NO. 1 TRANSMISSION CONTROL ECU BRACKET
|
(a) Remove the 2 screws and No. 1 transmission control ECU bracket from the TCM. |
|
7. REMOVE NO. 2 TRANSMISSION CONTROL ECU BRACKET
|
(a) Remove the 2 screws and No. 2 transmission control ECU bracket from the TCM. |
|
|
|