EA67F / EA68F (MANUAL TRANSMISSION / TRANSAXLE): TRANSMISSION CONTROL CABLE: ADJUSTMENT; 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022

Last Modified: 05-13-2024	6.11:8.1.0	Doc ID: RM1000000026XR7
Model Year Start: 2023	Model: GR Corolla	Prod Date Range: [09/2022 - ]
Title: EA67F / EA68F (MANUAL TRANSMISSION / TRANSAXLE): TRANSMISSION CONTROL CABLE: ADJUSTMENT; 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 - ]

ADJUSTMENT

PROCEDURE

1. SECURE VEHICLE

(a) Fully apply the parking brake and chock a wheel.

CAUTION:

Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to neutral, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

2. REMOVE CONSOLE BOX ASSEMBLY

Click here

3. REMOVE RADIATOR SUPPORT OPENING COVER

Click here

4. REMOVE NO. 1 AIR CLEANER INLET

Click here

5. REMOVE AIR CLEANER WITH AIR CLEANER HOSE

Click here

6. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY

HINT:

After the floor shift shift lever assembly or the transmission control cable assembly is replaced, be sure to adjust the transmission control cable assembly.
If the shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position, or if it is possible to move the shift lever to the reverse position without pulling up the slider shaft, the length of the transmission control cable assembly must be adjusted.

(a) Remove the clip and disconnect the transmission control select cable from the floor shift shift lever assembly.

(b) Slide the slider of the transmission control select cable in the direction indicated by the arrow in the illustration and pull the lock piece outward.

*a	Slider
*b	Lock Piece
*c	Slide
*d	Pull

NOTICE:

Check that the lock piece is pulled out.
Push the end of the transmission control select cable all the way to the base of the floor shift shift lever assembly pin.
Connect the transmission control select cable so that the lock piece faces the driver side.

*a	Lock Piece

(d) Pressing the shift and select lever shaft and shift and select lever pin, push in the shift and select lever pin and check that the shift and select lever shaft is secured at the 1st-2nd gear (the shaft comes to a stop at the position 8 mm (0.315 in.) below the N position).

*a	Press
*b	Press and Hold
*c	Push in the shift and select lever pin

(e) Push the slider shaft against the cam wall.

NOTICE:

Do not pull up the slider shaft.
When adjusting the transmission control select cable, make sure that the shift lever is not in 1st or 2nd.

*a	Slider Shaft
*b	Cam Wall

(f) Push the lock piece into the adjuster case.

NOTICE:

Securely push in the lock piece until the 2 claws are engaged.
When adjusting the transmission control select cable, make sure that the shift lever is not in 1st or 2nd.

*a	Lock Piece
*b	Adjuster Case
*c	Push in

(g) Release the shift and select lever pin that secures the shift and select lever shaft.

(1) Pull the shift and select lever pin toward the front left side of the vehicle.

Pull

7. INSTALL AIR CLEANER WITH AIR CLEANER HOSE

Click here

8. INSTALL NO. 1 AIR CLEANER INLET

Click here

9. INSTALL RADIATOR SUPPORT OPENING COVER

Click here

10. INSTALL CONSOLE BOX ASSEMBLY

Click here