- Poor idle, etc.
- Engine start function, etc.
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM1000000026XR6 |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - ] |
| Title: EA67F / EA68F (MANUAL TRANSMISSION / TRANSAXLE): TRANSMISSION CONTROL CABLE: REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback GR Corolla [09/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Gas leak from exhaust system is repaired |
Inspection after repair |
|
|
PROCEDURE
1. SECURE VEHICLE
(a) Fully apply the parking brake and chock a wheel.
CAUTION:
-
Make sure to apply the parking brake and chock a wheel before performing this procedure.
- If the vehicle is not secure and the shift lever is moved to neutral, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2. REMOVE CONSOLE BOX ASSEMBLY
Click here
![2023 MY GR Corolla [09/2022 - 11/2022]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (for G16E-GTS): REMOVAL](/t3Portal/stylegraphics/info.gif)
3. REMOVE RADIATOR SUPPORT OPENING COVER
Click here
4. REMOVE NO. 1 AIR CLEANER INLET
Click here
5. REMOVE AIR CLEANER WITH AIR CLEANER HOSE
Click here
6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Click here
7. REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR SUB-ASSEMBLY
|
(a) Remove the 3 nuts. |
|
(b) Disengage the clip to remove the No. 1 front floor heat insulator sub-assembly.
8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
|
(a) Remove the clip and disconnect the transmission control select cable from the floor shift shift lever assembly. |
|
(b) Disconnect the transmission control shift cable from the floor shift shift lever assembly.
|
(c) Using a screwdriver with its tip wrapped with protective tape, pull out the stopper of the transmission control select cable. NOTICE: Do not remove the stopper. If it is removed, reinstall it to its original position. |
|
|
(d) Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control select cable from the floor shift shift lever assembly. NOTICE:
|
|
(e) Disconnect the transmission control shift cable from the floor shift shift lever assembly in the same manner as the transmission control select cable.
|
(f) Remove the 2 clips (A) and washer to disconnect the transmission control cable assembly from the manual transaxle assembly. |
|
(g) Remove the 2 clips (B) to disconnect the transmission control cable assembly from the control cable bracket assembly.
|
(h) Remove the nut. |
|
(i) Disengage the guide and disconnect the transmission control cable assembly from the vehicle body.
|
(j) Remove the 2 nuts and transmission control cable assembly from the vehicle body. |
|
|
|