Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026XHO |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 - 11/2022] |
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B15C0,B15C1; GPS Antenna Connection Malfunction(short); 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022] |
DTC
|
B15C0
|
GPS Antenna Connection Malfunction(short)
|
DTC
|
B15C1
|
GPS Antenna Connection Malfunction(break)
|
DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
B15C0
|
GPS Antenna Connection Malfunction(short)
|
GPS Antenna Connection Malfunction(short)
|
-
Navigation antenna assembly
-
No. 2 antenna cord sub-assembly
-
Navigation ECU
|
B15C1
|
GPS Antenna Connection Malfunction(break)
|
GPS Antenna Connection Malfunction(break)
|
-
Navigation antenna assembly
-
No. 2 antenna cord sub-assembly
-
Navigation ECU
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
When replacing the navigation ECU, always replace it with a new one. If a navigation ECU which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The navigation ECU may not operate normally.
-
Check that the No. 2 antenna cord sub-assembly is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.
Click here
PROCEDURE
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble Codes
OK:
No DTCs are output.
NG
|
|
|
2.
|
INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY
|
(a) Remove the No. 2 antenna cord sub-assembly.
Click here
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A-3 - B-1
|
Always
|
Below 1 Ω
|
A-3a - B-1a
|
Always
|
Below 1 Ω
|
A-3 or B-1 - Body ground
|
Always
|
10 kΩ or higher
|
|
|
*a
|
Component without harness connected
(No. 2 Antenna Cord Sub-assembly)
|
|
|
OK
|
|
|
3.
|
INSPECT NAVIGATION ANTENNA ASSEMBLY
|
(a) Remove the navigation antenna assembly.
Click here
(b) Inspect the navigation antenna assembly.
Click here
|