Last Modified: 07-31-2024 6.11:8.1.0 Doc ID: RM1000000026WF1
Model Year Start: 2023 Model: GR Corolla Prod Date Range: [09/2022 -           ]
Title: MAINTENANCE: REAR DISC BRAKE PAD (w/ Electric Parking Brake): REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

  • Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
  • After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
  • After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 -        ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL

2. PERFORM REAR BRAKE PAD REPLACEMENT MODE

for HV Model: Click here 2023 - 2025 MY Corolla Corolla HV [09/2022 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM (for HV Model): TEST MODE PROCEDURE

for Gasoline Model: Click here 2019 - 2025 MY Corolla Corolla Hatchback GR Corolla [06/2018 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model): TEST MODE PROCEDURE

3. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Click here 2020 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 -        ]; PARKING BRAKE: ELECTRIC PARKING BRAKE ACTUATOR: REMOVAL+

4. REMOVE REAR DISC BRAKE PAD

CAUTION:

  • Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when removing the rear disc brake pads.
  • After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.
  • The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.

(a) Hold the rear No. 1 disc brake cylinder slide pin and remove the bolt.

*a

Hold

*b

Turn

(b) Pull the rear disc brake cylinder assembly upward.

(c) Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

5. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

(a) Remove the rear No. 1 disc brake anti-squeal shim and rear No. 2 disc brake anti-squeal shim from each rear disc brake pad.

*1

Rear No. 1 Disc Brake Anti-squeal Shim

*2

Rear No. 2 Disc Brake Anti-squeal Shim

*3

Rear Disc Brake Pad

(b) Using a screwdriver, remove the rear disc brake pad wear indicator plate from each rear disc brake pad.