Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026UVC |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 - 11/2022] |
Title: GF1A (TRANSFER / 4WD / AWD): 4WD CONTROL ECU: REMOVAL; 2023 MY Corolla Corolla Hatchback GR Corolla [09/2022 - 11/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the 4WD ECU removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
4WD ECU assembly
|
1.ECU Data Save (ECU being replaced)
|
Active Torque Split AWD System
|
|
2.ECU Configuration (New ECU)
|
Vehicle Control History (RoB) are stored
|
|
3.ECU Data Write (When replacing 4WD ECU assembly) (New ECU)
|
Active Torque Split AWD System
|
|
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
-
Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Necessary Procedures
|
Link
|
Front Camera System (for TMC Made)
|
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.
|
|
-
Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Necessary Procedures
|
Link
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
|
|
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click here
2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
Click here
3. REMOVE DECK BOARD ASSEMBLY
Click here
4. REMOVE SPARE WHEEL CUSHION
Click here
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
6. REMOVE REAR DECK TRIM COVER
Click here
7. REMOVE REAR SEAT HEADREST ASSEMBLY
Click here
8. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY
Click here
9. DISCONNECT REAR SEAT CENTER LAP TYPE BELT ASSEMBLY
Click here
10. REMOVE REAR SEATBACK ASSEMBLY RH
Click here
11. REMOVE REAR SEAT CUSHION ASSEMBLY
Click here
12. REMOVE REAR SEAT CUSHION LOCK HOOK
Click here
13. REMOVE REAR DOOR SCUFF PLATE RH
Click here
14. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Click here
15. REMOVE REAR SEAT SIDE GARNISH RH
Click here
16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
17. REMOVE 4WD ECU ASSEMBLY
(a) Disconnect the connector.
|
|
(b) Remove the 2 nut and 4WD ECU assembly.
|
|
|