Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026RTK |
Model Year Start: 2023 |
Model: Corolla Hatchback |
Prod Date Range: [09/2022 -
] |
Title: AXLE AND DIFFERENTIAL: FRONT AXLE HUB (except G16E-GTS): ON-VEHICLE INSPECTION; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV [09/2022 - ] |
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT WHEEL
Click here
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
Click here
3. REMOVE FRONT DISC
Click here
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator with magnetic base, check for looseness near the center of the front axle hub sub-assembly.
Maximum Looseness:
0.05 mm (0.00196 in.)
NOTICE:
-
Ensure that the dial indicator is set perpendicular to the measurement surface.
-
Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.
HINT:
If the looseness exceeds the maximum, replace the front axle hub sub-assembly.
|
|
5. INSPECT FRONT AXLE HUB RUNOUT
(a) Using a dial indicator with magnetic base, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.
Maximum Runout:
0.05 mm (0.00196 in.)
NOTICE:
-
Ensure that the dial indicator is set perpendicular to the measurement surface.
-
Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.
-
Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.
HINT:
If the runout exceeds the maximum, replace the front axle hub sub-assembly.
|
|
6. INSTALL FRONT DISC
Click here
7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
Click here
8. INSTALL FRONT WHEEL
Click here
|