Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026PZQ |
Model Year Start: 2023 |
Model: Corolla HV |
Prod Date Range: [09/2022 -
] |
Title: HYBRID / BATTERY CONTROL: HYBRID BATTERY SYSTEM (for LITHIUM-ION BATTERY with PA10): P1AFC00; System Voltage (AM) Circuit Voltage Below Threshold; 2023 - 2025 MY Corolla HV [09/2022 - ] |
DTC
|
P1AFC00
|
System Voltage (AM) Circuit Voltage Below Threshold
|
DESCRIPTION
The battery ECU assembly monitors its internal operation and will store these DTCs when it detects an internal malfunction.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
MIL
|
Warning Indicate
|
Note
|
P1AFC00
|
System Voltage (AM) Circuit Voltage Below Threshold
|
The battery ECU assembly shutdown memory procedure did not complete normally in consecutive 40 trips.
(1 trip detection logic)
|
-
Wire harness or connector
-
Battery ECU assembly
-
Fuse
|
Does not come on
|
Master Warning:
Comes on
|
SAE Code: P1AFC
|
CONFIRMATION DRIVING PATTERN
HINT:
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click here
-
Connect the GTS to the DLC3.
-
Turn the ignition switch to ON and turn the GTS on.
-
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
-
Turn the ignition switch off and wait for 2 minutes or more.
-
Turn the ignition switch to ON and wait for 11 seconds or more. *1
-
Turn the ignition switch off and wait for 2 minutes or more. *2
-
Perform the procedures *1 and *2 41 times or more.
-
Turn the ignition switch to ON and turn the GTS on.
-
Enter the following menus: Powertrain / HV Battery / Utility / All Readiness.
-
Check the DTC judgment result.
HINT:
-
If the judgment result shows NORMAL, the system is normal.
-
If the judgment result shows ABNORMAL, the system has a malfunction.
-
If the judgment result shows INCOMPLETE, perform driving pattern again.
WIRING DIAGRAM
Refer to the wiring diagram for DTC P056014.
Click here
CAUTION / NOTICE / HINT
CAUTION:
Refer to the precautions before inspecting high voltage circuit.
Click here
PROCEDURE
1.
|
CHECK FUSE (ECU-B NO. 2)
|
Click here
NG |
|
REPLACE FUSE (ECU-B NO. 2)
|
OK
|
|
|
2.
|
CHECK CONNECTOR CONNECTION CONDITION (BATTERY ECU ASSEMBLY)
|
Click here
NG |
|
CONNECT SECURELY
|
OK
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (AM VOLTAGE)
|
Click here
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY ECU ASSEMBLY POWER SOURCE CIRCUIT)
|
|