Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026PMT |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 - 11/2022] |
Title: CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM (for Gasoline Model): B15C111,B15C113; GNSS Antenna Circuit Short to Ground; 2023 MY Corolla Corolla Hatchback GR Corolla [09/2022 - 11/2022] |
DTC
|
B15C111
|
GNSS Antenna Circuit Short to Ground
|
DTC
|
B15C113
|
GNSS Antenna Circuit Open
|
DESCRIPTION
These DTCs are stored when a malfunction occurs in the telephone and GPS antenna (for Roof Side) circuit.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
B15C111
|
GNSS Antenna Circuit Short to Ground
|
Current to the GNSS antenna is lower than the malfunction threshold for 10 seconds or more when the engine switch is on (IG)
(Short circuit)
|
-
DCM (telematics transceiver)
-
Telephone and GPS antenna (for Front Side)*1
-
Telephone and GPS antenna cord (antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 2 antenna cord sub-assembly)
-
Telephone and GPS antenna (for Roof Side)*2
-
Telephone and GPS antenna cord (No. 3 antenna cord sub-assembly)*2
|
B15C113
|
GNSS Antenna Circuit Open
|
Current to the GNSS antenna is higher than the malfunction threshold for 10 seconds or more when the engine switch is on (IG)
(Open circuit)
|
-
DCM (telematics transceiver)
-
Telephone and GPS antenna (for Front Side)*1
-
Telephone and GPS antenna cord (antenna cord sub-assembly)
-
Telephone and GPS antenna cord (No. 2 antenna cord sub-assembly)
-
Telephone and GPS antenna (for Roof Side)*2
-
Telephone and GPS antenna cord (No. 3 antenna cord sub-assembly)*2
|
*1: for TMC Made
*2: for TMMMS Made
WIRING DIAGRAM
for TMC Made and Hatchback
for TMC Made and Sedan
for TMMMS Made
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.
Click here
PROCEDURE
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and wait for 10 seconds or more.
(d) Turn the Techstream on.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
(f) Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK:
No DTCs are output.
NG
|
|
|
(a) Choose the model to be inspected.
Result
|
Proceed to
|
for TMC Made
|
A
|
for TMMMS Made
|
B
|
A
|
|
|
3.
|
INSPECT TELEPHONE AND GPS ANTENNA (FOR FRONT SIDE)
|
(a) Remove the telephone and GPS antenna (for Front Side).
Click here
(b) Current consumption check:
(1) Measure the current consumption according to the value(s) in the table below.
Standard Current:
Tester Connection
|
Condition
|
Specified Condition
|
3 (core) - 3a (shield)
|
4.2 to 5.0 V applied between terminals 3 and 3a
|
10 to 30 mA
|
NOTICE:
Do not apply 6 V or more between terminals 3 and 3a.
HINT:
If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.
|
|
*a
|
Component without harness connected
(Telephone and GPS Antenna Assembly (for Front Side))
|
*b
|
Voltage Applied between Terminals
|
|
|
OK
|
|
|
(a) Choose the model to be inspected.
Result
|
Proceed to
|
for Hatchback
|
A
|
for Sedan
|
B
|
A
|
|
|
5.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the D telephone and GPS antenna cord (No. 2 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected
(Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the B telephone and GPS antenna cord (No. 2 antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected
(Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
D-3 - B-1
|
Always
|
Below 1 Ω
|
D-3 or B-1 - Body ground
|
Always
|
10 kΩ or higher
|
D-3a - B-1a
|
Always
|
Below 1 Ω
|
D-3a or B-1a - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
6.
|
REPLACE DCM (TELEMATICS TRANSCEIVER)
|
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
-
The engine switch must be off.
-
Do not exchange the DCM (telematics transceiver) with one from another vehicle.
7.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the D telephone and GPS antenna cord (antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected
(Telephone and GPS Antenna Cord (Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the B telephone and GPS antenna cord (antenna cord sub-assembly) connector.
|
|
*a
|
Component without harness connected
(Telephone and GPS Antenna Cord (Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
D-3 - B-1
|
Always
|
Below 1 Ω
|
D-3 or B-1 - Body ground
|
Always
|
10 kΩ or higher
|
D-3a - B-1a
|
Always
|
Below 1 Ω
|
D-3a or B-1a - Body ground
|
Always
|
10 kΩ or higher
|
8.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 3 ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the antenna connector from the telephone and GPS antenna (for Roof Side).
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 3 Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the antenna connector from the telephone and GPS antenna cord (No. 2 antenna cord sub-assembly).
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 3 Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
I-2 - H-2
|
Always
|
Below 1 Ω
|
I-2a - H-2a
|
Always
|
Below 1 Ω
|
I-2 or H-2 - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
9.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the antenna connector from the telephone and GPS antenna cord (No. 3 antenna cord sub-assembly).
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the antenna connector from the telephone and GPS antenna cord (antenna cord sub-assembly).
|
|
*a
|
Component without harness connected (Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G-2 - F-2
|
Always
|
Below 1 Ω
|
G-2a - F-2a
|
Always
|
Below 1 Ω
|
G-2 or F-2 - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
10.
|
INSPECT TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY)
|
(a) Disconnect the antenna connector from the telephone and GPS antenna cord (No. 2 antenna cord sub-assembly).
|
|
*a
|
Component without harness connected
(Telephone and GPS Antenna Cord (Antenna Cord Sub-assembly))
|
|
|
(b) Disconnect the antenna connector from the DCM (telematics transceiver).
|
|
*a
|
Component without harness connected
(Telephone and GPS Antenna Cord (Antenna Cord Sub-assembly))
|
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
E-2 - B-1
|
Always
|
Below 1 Ω
|
E-2a - B-1a
|
Always
|
Below 1 Ω
|
E-2 or B-1 - Body ground
|
Always
|
10 kΩ or higher
|
OK
|
|
|
11.
|
CHECK TELEPHONE AND GPS ANTENNA (FOR ROOF SIDE)
|
(a) Replace the telephone and GPS antenna (for Roof Side) with a known good one.
Click here
(b) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs
(c) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble Codes
OK:
No DTCs are output.
OK |
|
END (TELEPHONE AND GPS ANTENNA (FOR ROOF SIDE) IS DEFECTIVE)
|
NG
|
|
|
12.
|
REPLACE DCM (TELEMATICS TRANSCEIVER)
|
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
-
The engine switch must be off.
-
Do not exchange the DCM (telematics transceiver) with one from another vehicle.
|