| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM1000000026LK5 |
| Model Year Start: 2023 | Model: GR Corolla | Prod Date Range: [09/2022 - 11/2022] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION; 2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022] | ||
INSTALLATION
PROCEDURE
1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Check that the ignition switch (for Gasoline Model) or power switch (for HV Model) is off.
(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
for TMC Made:
- Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
for TMMMS Made:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
(c) Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
HINT:
Refer to How to Connect or Disconnect Airbag Connector.
Click here
![2023 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - 11/2022]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM (for TMC Made): HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR](/t3Portal/stylegraphics/info.gif)
|
(d) Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly. |
|
(e) Engage the 2 claws.
(f) Install the lower No. 1 instrument panel airbag assembly with the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
for G16E-GTS: Click here
except G16E-GTS: Click here
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL
Click here
4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
5. INSTALL NO. 1 INSTRUMENT SIDE PANEL
Click here
6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for G16E-GTS: Click here
except G16E-GTS: Click here
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
for Hatchback: Click here
for Sedan: Click here
8. INSTALL FRONT DOOR SCUFF PLATE LH
for Hatchback: Click here
for Sedan: Click here
9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M20A-FKS: Click here
for 2ZR-FAE: Click here
for 2ZR-FXE: Click here
for G16E-GTS: Click here
10. INSTALL DECK BOARD ASSEMBLY (for G16E-GTS)
Click here
11. PERFORM DIAGNOSTIC SYSTEM CHECK (for TMMMS Made)
Click here
12. INSPECT SRS WARNING LIGHT
for TMC Made: Click here
for TMMMS Made: Click here
13. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
|
|