Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026EAE |
Model Year Start: 2023 |
Model: GR Corolla |
Prod Date Range: [09/2022 -
] |
Title: REAR SUSPENSION: REAR STABILIZER BAR (for Hatchback): REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [09/2022 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear stabilizer bar removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Tire
|
ECU Data Initialization (When performing tire replacement after RoB code X2104 is output)
|
Active Torque Split AWD System
|
|
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. REMOVE REAR FLOOR SIDE MEMBER COVER LH (for 2WD)
(a) w/ Cover:
(1) Remove the 3 bolts and clip (A).
|
|
(2) Disengage the clip (B) to remove the rear floor side member cover LH.
3. REMOVE REAR FLOOR SIDE MEMBER COVER RH (for 2WD)
(a) w/ Cover:
(2) Disengage the clip to remove the rear floor side member cover RH.
4. REMOVE FRONT FLOOR COVER LH (for AWD)
Click here
5. REMOVE REAR FLOOR SIDE MEMBER COVER LH (for AWD)
Click here
6. REMOVE FRONT FLOOR COVER RH (for AWD)
Click here
7. REMOVE REAR FLOOR SIDE MEMBER COVER RH (for AWD)
Click here
8. REMOVE REAR STABILIZER LINK ASSEMBLY LH
(a) Remove the cap from the rear stabilizer link assembly LH.
(b) Loosen the nut (A) of the rear stabilizer link assembly LH.
HINT:
If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.
|
|
(c) Loosen the nut (B) of the rear stabilizer link assembly LH.
(d) Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.
NOTICE:
-
When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
-
Make sure to perform this operation with the vehicle kept as low as possible.
|
|
(e) Remove the bolt, 2 nuts and rear stabilizer link assembly LH.
|
|
9. REMOVE REAR STABILIZER LINK ASSEMBLY RH
HINT:
Perform the same procedure as for the LH side.
10. REMOVE REAR STABILIZER BAR (for 2WD)
(a) Remove the 4 bolts and rear stabilizer bar from the rear suspension member sub-assembly.
|
|
11. REMOVE REAR STABILIZER BAR (for AWD)
(a) Remove the 4 bolts, rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings from the rear suspension member sub-assembly.
|
|
12. REMOVE REAR NO. 1 STABILIZER BAR BRACKET (for AWD)
(a) Remove the 2 rear No. 1 stabilizer bar brackets from the 2 rear stabilizer bushings.
|
|
13. REMOVE REAR STABILIZER BUSHING (for AWD)
(a) Remove the 2 rear stabilizer bushings from the rear stabilizer bar.
|
|
|