THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function (Gasoline Model, except TMMMS Made)): B279C95; Engine Immobiliser System Incorrect Assembly; 2023 MY Corolla Corolla Hatchback GR Corolla [09/2022

DESCRIPTION

If an ECM that is incompatible with the immobiliser function is installed, the ECM will store this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B279C95

Engine Immobiliser System Incorrect Assembly

An ECM that is incompatible with the immobiliser function is installed. (1-trip detection logic*)

ECM

Vehicle Condition and Fail-safe Function when Malfunction Detected

Vehicle Condition when Malfunction Detected

Fail-safe Function when Malfunction Detected

Engine cannot be started

Related Data List and Active Test

DTC No.

Data List and Active Test

B279C95

CAUTION / NOTICE / HINT

NOTICE:

When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins.
Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Start Key(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
The smart key system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
Click here
Before replacing the ECM, refer to Registration.
Click here
After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

PROCEDURE

REPLACE ECM

(a) Temporarily replace the ECM with a new one.

HINT:

for M20A-FKS: Click here

for G16E-GTS: Click here

END (ECM WAS DEFECTIVE)