Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM1000000026D5C |
Model Year Start: 2023 |
Model: Corolla Hatchback |
Prod Date Range: [09/2022 -
] |
Title: AXLE AND DIFFERENTIAL: REAR AXLE HUB (for Double Wishbone Type Suspension 2WD with Electric Parking Brake): REMOVAL; 2023 - 2025 MY Corolla Corolla Hatchback Corolla HV [09/2022 - ] |
REMOVAL
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
(a) Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.
NOTICE:
-
Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.
-
Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.
|
|
(b) Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.
NOTICE:
Be careful not to damage the rear axle hub and bearing assembly or connector cover.
|
|
3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
4. REMOVE REAR DISC
Click here
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a) Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.
|
|
|